TQ R/C & Hobbies

Tamiya Mini 4WD Asia Challenge 2025 (TMAC 2025)

 

Referring to the announcement made by Tamiya, Inc. in their website : https://www.tamiya.com/english/newstopics/2025/singapore_malaysia_tmac.html regarding the qualification race of Tamiya Mini 4WD Asia Challenge 2025 (TMAC 2025) for Singapore and Malaysia racers, PT Tamindo Plastic Model / TQ R/C and Hobbies, is planning to conduct the qualification race for the racers from Singapore and Malaysia, with the following venue:


Day / Date : Sunday / 08 June 2025
Place : Mall Mangga Dua Square, 1st floor, Hall A
Registration open date: 24 May 2025
Registration closing date: 31 May 2025
Registration google form:

https://forms.gle/ZqUybUaVissSRpbb8

Registration fee: IDR 300,000 per racer, eligible for 20 run

Please kindly note that the organizer reserve full rights to cancel the event should the organizer deem the race participants to be too small and inefficient to conduct the race. We require minimum attendance of 10 racers from each country.  For example, if there is only 10 racers from country X and 2 racers from country Y, then we will only conduct the qualifications from country X only.

Regulation:

1.  Race system is bracket system 4-2-1

Each Racer will buy 1 card for 20 run for Stage 1
Stage 2, each Racer can only have 4 runs
Stage 3, each Racer can only have 2 runs
Stage 4, each Racer can only have 1 run and after this run car will be quarantined

2.  All parts MUST BE Tamiya original parts. 
3.  Racer can use their own rechargeable batteries
4.  Other regulation we will follow TMAC 2025 Stock Class (attached pdf)
5.  Other regulations if not yet stated or unclear, will be informed during the race and all decision from the organizer is FINAL.

Other things to note:

1.  Please note that all racers should bear their own tickets and accomodation to Jakarta.
2.  Winners from the qualifications for position 1-4 from each country, will only be given entry rights. They shall bear their own tickets and accomodations during TMAC 2025 in Taiwan.

MM-WTB2

Rate this item
(1 Vote)

 
Keep your battery pack warm under cold ambient.
New warming technology for LiPo, NiMH battery performance.
 
The Warming Tray is a warmer that can heat up your battery packs before charging in winter season.
Cold battery may loose punch(which means lower average voltage than usual) if you charge without any warming.
The Warming Tray can be connected to Cell Master charger or Warmer Controller 3080.
It has a thermic wire inside and will keep target temperature where you set to.
 
 
Li-Po battery available
(including separate)
 
Warming Tray 2 is optimized for Li-Po battery was designed.
Flat bottom surface from inside is heated up in the best condition of battery.
 
 
All-aluminum Shell
 
Warming Tray 2 have all-aluminum shell and good thermal conductivity.
also can warm up the battery evenly
 
Safety plate for charge Saddle Pack.
 
Safety plate keeps in safety when charging a battery.
Because of two charge clips do not touch each other due to the short circuit can prevent accidents.
 
The magnet
for thermo-sensor
 
WT3 have the magnet on the side.
It's easy to mount temperature sensor.
 
Cell Master Legend and Warmer Controller 3080
 
The WT3 can be connected to Legend charger or Warmer Controller 3080
 
 
 
More in this category: MLI-VG3300P »

Social sharing

Who's Online

We have 373 guests online